How to Clean a Grid Assembly

by | Jun 19, 2019

This training video covers how to clean a grid assembly.  Molybdenum grids require periodic cleaning depending upon usage. Deposition grids may need a cleaning every 250 hours of use. For assist source grids, they do not require frequent cleaning. Please refer to the grid assembly drawing for proper re-assembly.


You may also like

This is the title image for the video called Grid Install Troubleshooting
1:33
How to Troubleshoot Grid Installation
A training video that covers how to troubleshoot a grid installation if there are issues.
Grid installation video title
4:23
How to Install a Grid Assembly
A training video about installation of grid assemblies into ion beam sources.
How to Clean and Maintain Grids
12:21
How to Clean and Maintain Grids
A training video that covers grid maintenance.
Running a Source video title
2:45
16cm Ion Source: Normal Operation
This training video shows normal operation of an RF ion beam source using our IBEAM power supply.
This is a video titled Replacing Old Power Supplies with an I-Beam 703.
5:56
Replacing Legacy Power Supplies with the I-Beam 703
A short clip on how to install the IBEAM 703 power supply.
Intro to ion sources video title
3:31
Introduction to Ion Sources
This video introduces the ion sources that Plasma Process Group offers.
1234
Page 1 of 4